Buyer answer: A quality and handover checklist for OEM furniture-integrated wireless charging projects.
Product approval and installation approval are separate steps
A charging module may perform correctly on a supplier’s bench yet behave differently when concealed in furniture. A completed installation changes ventilation, spacing, cable movement and service access. Buyers should review the module specification and the proposed furniture integration as two linked deliverables.
Mechanical and electrical review
Confirm the mounting method and whether fasteners can loosen from vibration or repeated furniture movement. Identify a stable cable route that avoids sharp edges, crushing, liquids and heat sources. The power adapter should be serviceable or accessible according to the actual installation design. Do not bury a replaceable adapter in a sealed cavity without considering maintenance, heat and applicable electrical rules.
Functional inspection before handover
- Confirm the exact module part number and hardware revision.
- Measure the actual distance between transmitter and phone placement surface.
- Verify charging at the center and at reasonable user placement offsets.
- Test the intended case types and the charger with the specified input supply.
- Check surface heating after sustained operation under representative conditions.
- Confirm cable restraint, strain relief, user marking and accessible service instructions.
- Record the test results against a signed drawing and sample approval record.
| Failure mode | Practical prevention |
|---|---|
| Charger works only with a bare phone | Test a defined set of cases and offsets |
| Hot spot above module | Review panel material, ventilation and actual power |
| Cable damage over time | Add strain relief and inspect bend points |
| Wrong module installed | Match serial/lot and drawing revision |
| User cannot find charger | Provide an accurate surface location marker |
Qualification of materials and finishes
Wood, glass, certain plastics and composites may have different characteristics; do not assume every material is interchangeable. Pay attention to metallic laminates, hidden support frames and decorative layers. If the furniture is routinely cleaned or used in hospitality, define suitable cleaning and moisture precautions with the installer.
Documents to hand over
Ask for a controlled drawing, bill of materials, input requirements, installation instructions, operational limitations, inspection checklist, applicable certificates or reports for the exact model, and an escalation contact for failed units. The installer should document any deviations from the approved prototype.
This checklist supports procurement preparation; it is not a substitute for local electrical, furniture or product safety assessments. For quality expectations see ChargerNext quality control and submit an embedded charging RFQ.
Common buyer questions
Is a working bench sample sufficient for furniture installation?
No. Test the final panel assembly, including thickness, cable routing and ventilation.
Who approves an installed system?
Define responsibility between furniture manufacturer, installer, electronics supplier and the applicable market compliance reviewer.
Related ChargerNext reading
- Under-Desk Invisible Wireless Charging: Furniture Design Guide
- Wireless Charging Desk Mats: OEM Materials and Customization
- Browse the Charging Knowledge Center
Official references and further reading
Editorial note: This is B2B sourcing guidance, not a product certification, laboratory report, legal opinion or guarantee of model-level performance. Confirm the exact model, current source requirements and destination-market rules before purchase.
